Siemens SINAMICS G120 - Fig. 2-61 2804 - Basic Functions, Status words

Function diagrams Safety Integrated 2-562
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 / Control Units CU240B/E-2 Parameter Manual (LH11), 01/2011
Fig. 2-61 2804 – Basic Functions, Status words
- 2804 -
Function diagram
87654321
FP_2804_97_63.vsd
Safety Integrated
G120 CU240E-2 <**>
13.12.2010 V4.4
Basic Functions, Status words
1
9
10
...
15
0[2810.3]
[2810.7]
[2802.5]
[2802.8]
1
0
0
31[2810.5]
[2802.7]
...
...
SI status P1
r9772
r9772
SI general fct P1
r9771
Status word Safety Integrated
Processor 1
Bit No.
1 = STO selected on Processor 1
1 = STO active on Processor 1
Reserved
1 = STOP A cannot be acknowledged, active
Functions available on Processor 1 und
Processor 2
1 = STOP A active
Reserved
1 = STOP F active
Bit No.
Bit No.
Reserved
Status word Safety Integrated
Processor 1 and Processor 2
Functions available on Processor 1 und
Processor 2
1 = STO supported via terminals
1 = STO selected in drive
1 = STO active in drive
1 = The shutdown paths must be tested
17
18
16
19
20
1 = STO cause: Safety commissioning mode
1 = STO cause: selection via terminal
Reserved
1 = STO cause: missing actual value
1 = STO cause: selection PROFIsafe
SI status P1+P2
r9773
r9773
6
1 = PROFIsafe supported
...
Reserved
...
Reserved
[2810.3]
<**> Valid for all CU240E-2 variants
1
...
0[2810.3] &
&[2810.6]
SI Status P2
r9872
r9872
Bit No.
Reserved
Status word Safety Integrated
Processor2
1 = STO selected on Processor 2
1 = STO active on Processor 2
Status (Processor 1 + Processor 2)Status (Processor 2)Status (Processor 1)
<1>
only PROFIBUS variants
<1>