Siemens SINAMICS G120 - p20209 BI: BSW 0 switch setting I; BSW 0 sw_setting; r20210 BO: BSW 0 output Q; BSW 0 output Q; p20211 BSW 0 run-time group; BSW 0 RTG; p20212 BSW 0 run sequence; BSW 0 RunSeq

To Next Page

To Previous Page

Parameters

List of Parameters

1-432

SINAMICS G120 / Control Units CU240B/E-2 Parameter Manual (LH11), 01/2011

Description: Sets the signal source of the switch setting I of instance BSW 0 of the binary changeover switch.

Description: Display parameter for output quantity Q of instance BSW 0 of the binary changeover switch.

Description: Setting parameter for the run-time group in which the instance BSW 0 of the binary changeover switch is to be

called.

Value: 1: Run-time group 1

2: Run-time group 2

3: Run-time group 3

4: Run-time group 4

5: Run-time group 5

6: Run-time group 6

9999: Do not calculate

Description: Setting parameter for the run sequence of instance BSW 0 within the run-time group set in p20211.

Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run

sequence value.

Description: Sets the signal source of input quantities I0 and I1 of instance BSW 1 of the binary changeover switch.

Index: [0] = Input I0

[1] = Input I1

p20209 BI: BSW 0 switch setting I / BSW 0 sw_setting

Access level: 3 Calculated: - Data type: U32 / Binary

Can be changed: T Scaling: - Data set: -