Siemens SINAMICS G120 - p20329[0...3] BI: DFR 2 inputs; DFR 2 inputs; r20330 BO: DFR 2 output Q; DFR 2 output Q; r20331 BO: DFR 2 inverted output QN; DFR 2 inv outp QN; p20332 DFR 2 run-time group; DFR 2 RTG

To Next Page

To Previous Page

List of Parameters

Parameters

1-453

SINAMICS G120 Control Units CU240B/E-2 Parameter Manual (LH11), 01/2011

Description: Sets the signal source for trigger input I, D input D, set input S, and reset input R of instance DFR 2 of the D flipflop.

Index: [0] = Trigger input I

[1] = D input D

[2] = Set S

[3] = Reset R

Description: Display parameter for output Q of instance DFR 2 of the D flipflop.

Description: Display parameter for the inverted output QN of instance DFR 2 of the D flipflop.

Description: Setting parameter for the run-time group in which instance DFR 2 of the D flipflop is to be called.

Value: 1: Run-time group 1

2: Run-time group 2

3: Run-time group 3

4: Run-time group 4

5: Run-time group 5

6: Run-time group 6

9999: Do not calculate

Description: Setting parameter for the run-time group of instance DFR 2 within the run-time group set in p20332.

Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run

sequence value.

p20329[0...3] BI: DFR 2 inputs / DFR 2 inputs

Access level: 3 Calculated: - Data type: U32 / Binary

Can be changed: T Scaling: - Data set: -