12713020-003-2 Revision F.01 – January 2007 SSU-2000 Technical Reference 113
Chapter 2 TL1 Reference
Retrieve Setup Parameters
Retrieve Setup Parameters
This command returns the current, user, or factory setting of the module specified in
the command.
Syntax
RTRV-PRMTR-SETUP:[tid]:aid:ctag::which;
Response Format
The response format varies for each module.
For the Comms module:
^^^"PROMPT: name"<cr lf>
^^^"COML: mode,echo,eol,tout"<cr lf>
^^^"COMA: mode,echo,eol,tout"<cr lf>
^^^"COMB: mode,echo,eol,tout"<cr lf>
^^^"TELNET_TIMEOUT: tout"<cr lf>
^^^"TL1_TIMEOUT: tout"<cr lf>
^^^"TL1_KEEPALIVE: keepalive"<cr lf>
^^^"TL1_FORMAT:tl1 format"<cr lf>
^^^"PBO:pbo"<cr lf>
^^^"LOGIN_EVT_DIS:login_evt_dis"<cr lf>
^^^"ELEVATION:elevation"<cr lf>
^^^"TODSOURCE:todsource"<cr lf>
^^^"SNMP:snmp_ena"<cr lf>
^^^" SNMP_KEEPALIVE: keepalive "<cr lf>
^^^" SNMP_TRAP: trap "<cr lf>
where:
name is the Unit's name
mode indicates the mode of communication {ASCII | TL1}
echo indicates if the port operates in full-duplex or half-duplex {ON |
OFF} mode
eol indicates the end-of-line character to be used when the unit
transmits ASCII data {CR | LF | CRLF}
tout indicates the inactivity timeout period before the session is
logged out {value | NEVER}. Some data fields shall be left blank
for Telnet parameters
Parameter Value Description
which current
Returns the current settings in the specified module [or port].
user Returns the User settings stored in the specified module
[or port].
factory Returns the Factory settings for the specified module [or
port].
aid SxAy[-z] Specifies the module [or port].
To Next Page
Loading...
Need help?
General
