Chapter 6 Alarms and Events
Communication Module Alarms and Events
300 SSU-2000 Technical Reference 12713020-003-2 Revision F.01 – January 2007
Basic + SNMPv3 and Basic + NTP + SNMPv3
Table 6-7 lists the alarms and events for the following Communication module
firmware versions:
Basic + SNMPv3 (24113012-004-0)
Basic + NTP + SNMPv3 (24113012-005-0)
This table includes the typical response for each alarm or event, it’s event number,
and a description or a suggested corrective action. The SNMP MIB trap is listed in
the Alarm/Event/Trap Description column.
204 SNMPv2 Manager, INIT,
192,5.41.39, COML
An SNMP Manager has been initialized at the IP address shown.
206 SNMP Trap, ALM, COML The SNMP Trap Port has been set to send traps on alarms only.
207 Chg KeepAlive, ALL, 15
minutes, COML
The Keep Alive timer has been set to the interval shown.
208 Operating Mode,
Subtending, COML
A user has changed the operating mode.
209 Notification, V3, COML A user has changed the notification format.
210 Login Event, Enable, COML A user has changed whether login events are stored.
211 TL1 Format, GR831, COML A user has changed the TL1 format to the specified value.
212 SNMPv3 User, ADD, id=1,
COML
An SNMP user has been added to the user table in the position
shown.
213 SNMPv3 Manager,
INIT<192.5.41.39, COML
An SNMP Manager has been initialized at the IP address shown.
251 Err Delay, (1), 300 sec,
COML
A user has changed the alarm delay time.
252 Alm Level, (2), Rep, COML A user has changed the alarm level.
253 Elevate Time, 3600 sec,
COML
A user has changed the alarm elevation time.
254 Setup, Save, COML A user has saved the setup to the user default.
Table 6-6. Basic +SNMPv2 and Basic +NTP + SNMPv2 Communications Module Alarm and Event Messages
(Continued)
Alarm/
Event/
Trap ID
Typical Alarm/Event/Trap
Response
Description/
Corrective Action
To Next Page
Loading...
Need help?
General
