Chapter 2 TL1 Reference
Retrieve Module Alarms
38 SSU-2000 Technical Reference 12713020-003-2 Revision F.01 – January 2007
Retrieve Module Alarms
This command returns only alarm information from the specified modules from the
stored event data. An aid or aid range may be used to limit the report to specified
modules. The aid code is optional. With an aid of ALL or null, all alarm data between
start and stop time is returned.
Syntax
RTRV-EVENT-ALARM:[tid]:[aid]:ctag::[count],[start],[stop];
Response Format
One line containing the time stamp and event message is returned for each alarm in
the log.
^^^"aid:ntfcncde,condtype,srveff,ocrdat,ocrtm:condscr" <cr lf>
where:
aid = module access identifier
ntfcncde = Notification Code [CR | MJ | MN | CL]
condtype = Condition Type (event number)
srveff = service affecting flag [SA | NSA]: SA = service affecting, NSA =
non-service affecting
ocrdat occurrence date
ocrtm = occurrence time
condstr = condition description string
Parameter Value Description
[aid] ALL or null Retrieves alarm data between the specified start and stop
time from all modules.
SxAy Retrieves alarm data between the specified start and stop
time from the specified module.
[count] 1 – 500 Specifies the number of alarms to retrieve. The default
count is 1.
[start] MM-DD,
HH:MM
Specifies the start date and time for data. If the date is null
but followed by a time, the command defaults to the current
date. If the start time is null, but preceded by a date, the
command defaults to the current time. If the start date and
time are null, the command defaults to the start of the data.
The comma must be present to indicate a null start time.
[stop] MM-DD,
HH:MM
Specifies the stop date and time for data. If the date is null
but followed by a time, the command defaults to the current
date. If the stop time is null but preceded by a date, the
command defaults to the current time. If the stop date and
time is null, the command defaults to the end of the data.
To Next Page
Loading...
Need help?
General
