12713020-003-2 Revision F.01 – January 2007 SSU-2000 Technical Reference 51
Chapter 2 TL1 Reference
Retrieve DS1/E1 Input Parameters
Retrieve DS1/E1 Input Parameters
This command returns the settings for the DS1 or E1 Input module or port
designated by the aid.
Syntax
RTRV-PRMTR-INPUT:[tid]:[aid]:ctag;
Response Format
^^^"aid:pstate,pri,pql,mode,ssm,zs,crc,gain,csflt,bit" <cr lf>
where:
aid = module or port access identifier
pstate = port enabled state [ON | OFF]
pri = priority 1 (highest) through 10 (lowest) or MON for monitor
pql = provisioned priority quality level [1 – 16]
mode = framing type or clock frequency in MHz: [ESF | D4 | CCS | CAS | 1 | 1.544
|2.048 | 5 | 10]
ssm, zs, crc, and gain = [ON | OFF]
csflt = Cesium fault [HI | LO | OFF | NA]
bit = bit number 4 through 8 of the Time Slot 0 word used for the E1 sync status
message
Related Commands
Set DS1/E1 Input Parameters, on page 142
Parameter Value Description
[aid] ALL Retrieves the parameters from all DS1 or E1 Input
modules in the shelf.
SxAy[-z] Retrieves parameters from the specified DS1 or E1 Input
module [or port].
To Next Page
Loading...
Need help?
General
