12713020-003-2 Revision F.01 – January 2007 SSU-2000 Technical Reference 347
Chapter 8 Default Settings
This chapter contains tables that list the factory default settings for the SSU-2000. If
you make any changes to the factory default settings, record them in Table 8-18 for
future reference. Use the “SETUP” command to verify settings.
In This Chapter
Communications Module Default Settings
Clock Module Default Settings
DS1 and E1 Input Module Default Settings
GPS Input Module Default Settings
Japanese CC Input Module Default Settings
Japanese Sine Wave Input Module Default Settings
DS1 and E1 Line Re-timing Module Default Settings
DS1 and E1 Output Module Default Settings
2048 kHz Output Module Default Settings
E1/2048 kHz Output Module Default Settings
Composite Clock Output Module Default Settings
RS-422 Output Module Default Settings
Japanese CC Output Module Default Settings
Japanese Sine Wave Output Module Default Settings
Priority Quality Level (PQL) Table Default Settings
User Changes to Factory Defaults
To Next Page
Loading...
Need help?
General
