Chapter 2 TL1 Reference
Set GPS Position
150 SSU-2000 Technical Reference 12713020-003-2 Revision F.01 – January 2007
Set GPS Position
This command sets the position mask for the GPS module designated by the aid.
Syntax
SET-GPS-POS:[tid]:[aid]: ctag::[(lat)],[(lon)],[(hgt)],[pdop],[avg],
[posel],[timel];
Related Commands
Retrieve GPS Data, on page 67
Retrieve GPS Available Data, on page 66
Retrieve GPS Input Parameters, on page 69
Parameter Value Description
[aid] S1A3 | S1A5 Sets the parameters for the specified GPS Input
module.
[lat] ±HH-MM-SS.ss Sets the latitude of the position. + is North, – is South.
[lon] ±HH-MM-SS.ss Sets the longitude of the position. + is East, – is West.
[hgt] ±10 000.0 Sets the altitude of the location of the shelf in m.
[pdop] 1 to 10 Sets the Position Dilution of Precision (PDOP)
number.
[avg] 10 to 3600 Sets the averaging value.
[posel] 0 to 50 Sets the minimum satellite elevation level in degrees
for positioning.
[timel] 0 to 50 Sets the minimum satellite elevation level in degrees
for timing.
To Next Page
Loading...
Need help?
General
