Symmetricom SSU-2000 Technical Reference

12713020-003-2 Revision F.01 – January 2007 SSU-2000 Technical Reference 245
Chapter 3 ICS Command Reference
SNMP
SNMP
Use this command to provide access to the SNMP user list and provide the SNMP
manager IP addresses.
Level 0: NA
Level 1:
SNMP [V2USER|V2MANAGER|V3USER|V3MANAGER]
If this command is used with any operand, it displays the valid SNMP
user names and their associated access levels. It also displays the
SNMP enabled/disabled mode, and SNMP manager IP addresses.
Options are:
V2USER Displays the valid SNMPv2 user names and their
associated access levels.
V2MANAGER Displays the SNMPv2 manager table contents.
V3USER Displays the valid SNMPv3 user names and their
associated access levels.
V3MANAGER Displays the SNMPv3 manager table contents.
Level 2: Same as level 1 operation
Level 3: Same as level 2 operation, with the following additions:
SNMP [DISABLE|ENABLE{V2|V3|ALL}]
SNMP TRAP {ALARM|ALL}
SNMP NOTIFICATION {V2|V3|ALL}
Options are:
DISABLE Disables the SNMP agent.
ENABLE Enables the SNMP agent and allow MIB manager to see
the view.
TRAP Allows user set filter for SNMP trap (event port).
ALARM Only Alarm Traps sent out.
ALL All Traps sent out.
NOTIFICATIONSNMP notification sent out in V2, V3, or both.
Level 4: Same as level 3 operation, with the following additions:
SNMP V2USER [{INIT|ADD|MODIFY|DELETE}]
SNMP V2MANAGER [INIT|{ADD|DELETE}] [ipAddress]
SNMP V3USER [{INIT|ADD|MODIFY|DELETE}]
SNMP V3MANAGER [INIT|{ADD|DELETE}] [ipAddress][username]
Options are:

Symmetricom SSU-2000 Specifications

General

Brand	Symmetricom
Model	SSU-2000
Category	Power Supply
Language	English