12713020-003-2 Revision F.01 – January 2007 SSU-2000 Technical Reference 153
Chapter 2 TL1 Reference
Set Japan Sine Input Parameters
Set Japan Sine Input Parameters
This command sets the parameters for the specified Japan Sine Input module or
ports. If
ALL is specified, then the command applied to all Japan Sine Input modules
in the shelf.
Syntax
SET-PRMTR-INPSINE:[tid]:[aid]:ctag::[pstate],[pri],[pql],[frequency],
[csflt];
Related Commands
Retrieve Japan Sine Input Parameters, on page 78
Parameter Format Description
aid S1Ay[-z] Sets the parameters for the specfied Japan Sine Input
module [or port].
pstate ON | OFF Turns the specified module [or port] on or off.
pri 1 - 10 |
MON
Sets the Priority for the specified module [or port]; MON =
Monitor.
pql 1 - 16 Sets the Priority Quality Level for the specified module [or
port].
frequency 1.544 |
6.312
Sets the frequency (in MHz) expected on the input.
csflt HI | LO
|OFF
Sets the external Cesium fault alarm input.
To Next Page
Loading...
Need help?
General
