Symmetricom SSU-2000 Technical Reference

Chapter 2 TL1 Reference
Set User Parameters
180 SSU-2000 Technical Reference 12713020-003-2 Revision F.01 – January 2007
Set User Parameters
This command allows changes to the user list.
Syntax
SET-USER:[tid]::ctag::mode,[username],[password],[userlevel];
You must issue the SET-PWD-CONFIRM command immediately after issuing this
command with the ADD, PWD, or TMP mode parameter.
Related Commands
Set Password Confirm, on page 168
Parameter Format Description
mode ADD | PWD
ACC | DEL
INIT | DIS
ENA | ULK
TMP
 ADD – Adds an entry to the user table. Requires
username, password., and level. Password
confirmation is required.
 PWD – Changes a user’s password. Requires
username and password. Password confirmation is
required.
 ACC – Changes a user’s access level. Requires
username and password.
 DEL – Deletes a single entry from the user table.
Requires username.
 INIT – Clears all entries in the user table, except
Guest and Admin. Does not require any other fields.
 DIS – Disables a user in the user table. Requires
username.
 ENA – Enables a user in the user table. Requires
username.
 ULK – Unlocks a user that is locked out. Requires
username.
 TMP – Temporarily changes a user’s password. The
user must change the password on first log-in.
Requires username and password. Password
confirmation is required.
username Specifes a user name, up to 20 characters long.
password Specifes a password, up to 20 characters long.
userlevel 1 - 4 Defaults to 1 if not entered.

Symmetricom SSU-2000 Specifications

General

Brand	Symmetricom
Model	SSU-2000
Category	Power Supply
Language	English