Chapter 2 TL1 Reference
Set E1/2048 kHz Output Parameters
146 SSU-2000 Technical Reference 12713020-003-2 Revision F.01 – January 2007
Set E1/2048 kHz Output Parameters
This command sets the output parameters for the specified E1/2048 kHz Output
module or port.
Syntax
SET-PRMTR-OUTE12048:[tid]:[aid]:ctag::[pstate],[bypass],[zs],
[signal],[squelch],[mframe],[crc],[ssm],[bit];
Related Commands
Retrieve E1/2048 kHz Output Parameters, on page 60
Parameter Format Description
aid SxAy[-z] Sets the parameters for the specfied module [or port].
pstate ON | OFF Enables or disable the specified module [or port].
bypass ON | OFF Allows operation when Clock C is the active clock.
zs ON | OFF Turns zero suppression on or off for the specified module
[or port].
signal E1 | 2048 Sets the output mode of the specified module [or port].
squelch 0 | 1 - 16 Turns off the specified port if the reference clock PQL
exceeds the squelch threshold specified in this field. 0
disables the function.
mframe CAS | CCS Sets the multiframe mode for the specified module [or
port].
crc ON | OFF Eanbles or disables error checking.
ssm ON | OFF Sets the specified module [or port] to read or ignore
incoming Sync Status Messages.
bit 4 - 8 Sets the bit number of the Time Slot 0 word used for the
E1 SSM.
To Next Page
Loading...
Need help?
General
