Chapter 2 TL1 Reference
Retrieve SNMP Mode Parameter
118 SSU-2000 Technical Reference 12713020-003-2 Revision F.01 – January 2007
Retrieve SNMP Mode Parameter
This command returns the current SNMP mode.
Syntax
RTRV-PRMTR-SNMP-MODE:[tid]::ctag;
Response Format
^^^"mode,trap" <cr lf>
where:
mode = [ENA | ALM | ENAV2 | ENAV3];
ENA enables all SNMP agents
DIS disables all SNMP agents
ENAV2 enables SNMPv2 agents
ENAV3 enables SNMPv3 agents
trap = [ALM | ALL];
ALM = Only alarms cause Traps to be transmitted
ALL = All events and alarms cause Traps to be transmitted
Related Commands
Set SNMP Mode Parameter, on page 173
To Next Page
Loading...
Need help?
General
