12713020-003-2 Revision F.01 – January 2007 SSU-2000 Technical Reference 93
Chapter 2 TL1 Reference
Retrieve Name
Retrieve Name
This command returns the name assigned to the shelf or to Input or Output ports,
excluding the Line Retiming Module. One name of up to 20 characters is returned
for each port designated by the aid.
Syntax
RTRV-NAME:[tid]:[aid]:ctag;
Response Format
When the aid is S1A2, the name of the unit is returned. When the aid is an I/O
module or port, the assigned port name is returned. If no name is assigned to a port,
then a null field is returned.
^^^"aid:name" <cr lf>
Related Commands
Retrieve Header, on page 71
Set Name, on page 162
Parameter Value Description
[aid] S1A2 Retrieves the name from the unit.
SxAy[-z] Retrieves the name from the specified module [or port]..
To Next Page
Loading...
Need help?
General
