Symmetricom SSU-2000 Technical Reference

12713020-003-2 Revision F.01 – January 2007 SSU-2000 Technical Reference 317
Chapter 6 Alarms and Events
LRM Alarms and Events
Quad DS1 LRM
Table 6-20 lists the alarms and events for the Quad DS1 Line Re-timing Module,
and includes the typical response for each alarm or event, it’s event number, and a
description or a suggested corrective action. The SNMP MIB trap is listed in the
Alarm/Event/Trap Description column. Table 6-21 lists the default parameters for the
DS1 Line Re-timing Module alarms.
146 Signal Path, CT/A
Disengaged, LOS
Signal is through re-timer module or cut-through
193 Port Cntl, Port[2-3], Disable,
COML
Port control on ports 2 and 3 disabled
196
SlipCount, Port[2-3], 4, COML Slip count on ports 2 and 3 set to 4
197
BPV Err, Port[2-3], Clr, COML Clear BPV accumulated error count
198 Fault Strategy, Port[2-3],
Squelch, COML
Reference Fault Strategy for CTA Action
199 Circuit ID, Set Port Circuit ID set
251 Err Delay, (0), 10 sec, COML An alarm delay time change
252 Alm Level, (1), Min, COML An alarm level change
254 Setup, Factory, COML User defaults have been set and saved
Table 6-19. E1 LRM Module Alarm Defaults
ID Description Alarm Level
000 LOS
001 AIS
002 OOF
003 BPV
004 SLIP
005 LOS Side2
010 REF PLL
011 CT/A Fuse
12 CT/A
Table 6-18. E1 LRM Alarm and Event Messages (Continued)
Alarm/
Event/
Trap ID
Typical Alarm/Event/Trap
Response
Description/
Corrective Action

Symmetricom SSU-2000 Specifications

General

Brand	Symmetricom
Model	SSU-2000
Category	Power Supply
Language	English