12713020-003-2 Revision F.01 – January 2007 SSU-2000 Technical Reference 163
Chapter 2 TL1 Reference
Set NTP Parameters
Set NTP Parameters
This command sets the NTP client and NTP broadcast mode of operation.
Syntax
SET-PRMTR-NTP:[tid]::ctag::mode,ip,interval,prefer;
Related Commands
Retrieve NTP Parameters, on page 95
Parameter Format Description
mode
CLIENT |
BCLIENT |
BROADCAST |
DEL |
CLRALL
Sets the mode of operation, where:
Client mode requests the time from the time server
(specified by ip); this time sets the time in the SSU.
Bclient mode accepts time from a broadcast
server specified by ip.
Broadcast mode configures the SSU as a
broadcast time server at the specified ip, the
broadcast interval (in seconds) defines the rate at
which the time will be broadcast by the server.
The del mode deletes the server specified by ip
from the list of peers; up to three ip’s can be
assigned for all peer modes combined.
Clrall deletes all peer addresses. If three ip’s have
been defined and a fourth ip is defined, the system
returns a DENY message; you must delete one of
the existing ip’s prior to adding the new ip.
ip Sets the IP address of the NTP server.
interval Sets the rate (in seconds) at which the time is to be
broadcast by the server.
prefer GPS |
CLIENT
Selects the time-of-day source in the SSU from GPS or
an NTP client.
To Next Page
Loading...
Need help?
General
