12713020-003-2 Revision F.01 – January 2007 SSU-2000 Technical Reference 227
Chapter 3 ICS Command Reference
NTP
NTP
Use this command to provide access to the NTP (Netswork Timing Protocol)
parameters in the SSU-2000. NTP can run as a server application, a client
application, and in broadcast mode. The server always runs and the client and
broadcast modes are enabled independently by assigning an address and setting a
timer.
Level 0: NA
Level 1:
NTP
Displays the NTP data: root delay, root dispersion, peer delay, peer
dispersion, and peer offset.
Level 2: Same as level 1 operation.
Level 3:
NTP ADDPEER {CLIENT|BROADCAST|BCLIENT} ip_dotted_address
NTP DELPEER ip_dotted_address
NTP CLRALL
NTP BTIMER {32|64|128|256|512|1024}
NTP {SETUP|STATUS}
NTP PREFER {GPS|CLIENT}
Options are:
ADDPEER Add NTP peers (servers) to enable broadcast or client
mode
CLIENT The IP for NTP server in client mode
BROADCAST The subnet mask for broadcasting mode
BCLIENT The IP for NTP server in broadcast client mode
DELPEER Removes NTP servers from the peer table
CLRALL Clear all the NTP peer addresses in the unit
BTIMER Set the broadcast timer for 32/64/128/256/512/1024
seconds interval
SETUP Display NTP setup information
STATUS Display NTP status information (default setting)
PREFER Selects the Time-of-Day source from GPS for as an NTP
client
Level 4: Same as level 3 operation
Remarks None
Related None
To Next Page
Loading...
Need help?
General
