Chapter 8 Default Settings
User Changes to Factory Defaults
362 SSU-2000 Technical Reference 12713020-003-2 Revision F.01 – January 2007
User Changes to Factory Defaults
Use Table E-11 to record any changes you make to the factory default settings.
Table 8-18. User Changes to Factory Default Settings
Setting Factory Default User Changes
Communications Module Defaults
Unit Name SSU_2000
Module Information
configurations
Current Configuration = the configuration that
is currently in use
User Default Configuration = configuration the
user specifies as the default if the current
configuration is invalid or not present
Factory Configuration = the factory default
configuration
User List
configurations
Maximum of 25 users including four built-in
users
EIA-232-C Port
Comm Port Timeout
All three comm ports are set to 9600 baud,
Interactive Mode, CRLF, and Echo on
Five minutes for all (Interactive Mode). (Note:
the unit should have one user added, i.e. not
in the INITUSERTABLE state). If it is in the
INITUSERTABLE state, no timeout is applied.
No Timeout is assigned for the TL1 Mode
Ethernet IP Address IP Address 0.0.0.0
Gateway Address 0.0.0.0
Network Mask 255.255.255.0
Clock Module 1
Warmup Time 1200 s
Min Tau Limit 2E: 300 s
TYPE I: 150 s
3E: 150 s
Max Tau Limit 2E: 10 000 s
TYPE I:1200 s
3E: 1200 s
To Next Page
Loading...
Need help?
General
