Chapter 2 TL1 Reference
Set Name
162 SSU-2000 Technical Reference 12713020-003-2 Revision F.01 – January 2007
Set Name
This command assigns a new name to the unit when you set the aid to S1A2
(Communications Module) or omit the aid. The tid (if used) must match the original
name, which is returned in the response sid. The new unit name must be used as
the tid (and sid) for all commands following.
When you set the aid that designates an Input or Output port, the name is assigned
to the port. The name for unit or port may be null or as many as 20 characters
beginning with a letter. This command does not apply to the D1 or E1 Line
Re-Timing Module; use the command described in Set LRM Circuit ID, on page
159.
Syntax
SET-NAME:[tid]:[aid]:ctag:: name;
Related Commands
Retrieve Name, on page 93
Set LRM Circuit ID, on page 159
Parameter Format Description
aid S1A2 Sets the name of the shelf to the value in [name]
SxAy[-z] Sets the specified module [or port] to the name specified
in [name]
name up to 20
characters
Defines the name for the device specified in [aid]
To Next Page
Loading...
Need help?
General
