12713020-003-2 Revision F.01 – January 2007 SSU-2000 Technical Reference 141
Chapter 2 TL1 Reference
Set Date and Time
Set Date and Time
This command changes the date and time in the Communications module. All
timestamps are affected by this change. The SSU-2000 system clock shall be set to
the received date and time and a complied message shall be returned, with the new
date/time in the header. If the unit has time set by GPS or NTP client, the DENY
response is returned.
Syntax
SET-DAT:[tid]::ctag::date,time,offset;
Response
The SSU-2000 clock is set to the received date and time and a complied message
is returned, with the new date/time in the header.
Related Commands
Retrieve Header, on page 71
Parameter Format Description
date yy-mm-dd Specifies the date.
time hh:mm:ss Specifies the time.
offset +/-HH:MM Sets the local time difference between local and UTC
time. If the local time is ahead of UTC, then use a
positive number; if the local time is behind UTC, then use
a negative number. The valid range is +/– 13 hours.
To Next Page
Loading...
Need help?
General
