12713020-003-2 Revision F.01 – January 2007 SSU-2000 Technical Reference 243
Chapter 3 ICS Command Reference
SETUP
SETUP
Use this command to view the current settings from non-volatile RAM in the entire
unit. This includes any user settable information that is currently stored in NVRAM.
The main purpose of this command is to provide a dump of the unit’s current
configuration so that you can compare site configurations. In addition, this
command allows for storage and restoration of user settings, and the restoration of
factory settings.
Level 0 Not applicable
Level 1
SETUP [xAy]
If you do not specify a parameter, all setup information for every module
in the unit displays. If a specified address operand is provided, setup
detail information for the target module displays. Module alarm Level is
handled by the ALARM command. The alarm elevation time is handled
by the ELEVTIME command. For each target module, refer to INPUT,
CLK, or OUTPUT for a description.
If xAy specifies a Buffer module, the command displays nothing.
If xAy specifies the Communications module, the command displays: IP
address, IP mask, gateway address, communications port settings, total
number of users stored, and maximum number of events stored. You
can view events from the event log by using the EVENTS command. You
can view alarms from each module by using the ALARM command.
SETUP xAy REPORT {CURRENT|FACTORY|USER}
Options are:
CURRENT Use this option to restore the current settings.
FACTORY Use this option to display the current factory settings.
USER Use this option to display the current user settings.
Level 2 Same as Level 1 operation
Level 3 Same as Level 2 operation, with the following additions:
SETUP [xAy] {FACTORY|USER|SAVE}
SETUP 1A2 CONNECTION FACTORY
Options are:
FACTORY Use this option to restore the current setting from the
factory settings. If addressed as COMM, connection and
user list are not included.
To Next Page
Loading...
Need help?
General
