Symmetricom SSU-2000 Technical Reference

Chapter 2 TL1 Reference
Retrieve Communication Parameters
48 SSU-2000 Technical Reference 12713020-003-2 Revision F.01 – January 2007
Retrieve Communication Parameters
This command returns the current serial communications protocol settings for the
SSU-2000.
Syntax
RTRV-PRMTR-COMM:[tid]:[aid]: ctag;
Response Format
When the aid specifies a port, the format for the response message line is:
^^^"aid:baud,echo,eol,mode,tout"<cr lf>
where:
 aid = communication port access identifier
 baud = communications baud rate [19200 | 9600 | 4800 | 2400 | 1200]
 echo = indicates if the port operates in full-duplex or half-duplex [ON | OFF]
 eol = indicates the end-of-line character used when the unit transmits ASCII data
[CR | LF | CRLF]
 mode = mode of communication [ASCII | TL1]
 tout = inactivity timeout period before the session is logged out [value | NEVER]
When the aid specifies a Telnet port, the format of the response message is:
^^^"aid:,,,,tout"<cr lf>
where:
 aid = communication port [TELNET | TL1]
 tout = inactivity timeout period before the session is logged out [value | NEVER]
Related Commands
Set Communication Parameters, on page 140
Parameter Value Description
[aid] ALL Retrieves the parameters from all communication
ports in the shelf.
COML | COMA |
COMB
Retrieves parameters from the specified serial port.
TELNET | TL1 Retrieves parameters from the specified telnet port.

Symmetricom SSU-2000 Specifications

General

Brand	Symmetricom
Model	SSU-2000
Category	Power Supply
Language	English