12713020-003-2 Revision F.01 – January 2007 SSU-2000 Technical Reference 95
Chapter 2 TL1 Reference
Retrieve NTP Parameters
Retrieve NTP Parameters
This command returns the current Network Timing Protocol settings for the shelf.
Syntax
RTRV-PRMTR-NTP:[tid]::ctag;
Response Format
^^^"ip1,mode,interval"<cr lf>
^^^"ip2,mode,interval"<cr lf>
^^^"ip3,mode,interval"<cr lf>
^^^"PREFER:todSource"<cr lf>
where:
ip = the server ip used by the client or broadcast client or broadcast server.
mode = the operating mode for the given ip [CLIENT | BCLIENT | BROADCAST].
In CLIENT mode, the SSU automatically requests the time from the server. In
BCLIENT mode, the server designated by the ip is a broadcast server. In
BROADCAST mode, the SSU is set up as a broadcast server.
interval = broadcast interval [32 | 64 | 128 | 512 | 1024] seconds; used when
the SSU is set up as a broadcast server. The SSU is automatically configured as
an NTP server with the address specified in the SET-PRMTR-IP command. Up to
three NTP ips may be listed.
todSource = the preferred TOD source [GPS | CLIENT]
Example
SSU_2000 06-06-26 15:08:18
M 100 COMPLD
"172.16.21.19,CLIENT"
"172.16.21.42,CLIENT"
"PREFER:CLIENT"
;
Related Commands
Set NTP Parameters, on page 163
To Next Page
Loading...
Need help?
General
