Symmetricom SSU-2000 Technical Reference

Chapter 8 Default Settings
Japanese Sine Wave Output Module Default Settings
360 SSU-2000 Technical Reference 12713020-003-2 Revision F.01 – January 2007
Japanese Sine Wave Output Module Default Settings
The factory default setting and range for all Japanese Sine Wave Output module
software parameters are listed in
Table 8-16 .
Operating Mode Normal (SSU) Normal | Japanese |
Subtending
JCC4 (400 Hz) Sync Enable Enable | Disable
Port Delay 3 (1375 feet) in Normal
mode, 7 (275 feet) in
Subtending mode
0 to 7
(2200, 1925, 1650, 1375,
1100, 825, 550, and 275
feet)
Port Label (Per Port) Null 0 – 20 ASCII printable
characters.
Alarm Elevation 86 400 s 60 – 500 000 s, 0 is disabled
Table 8-16. JSW Output Module Configuration Data
Setting Default Range
Frequency (Per Module) 6.312 1.544 | 6.312
Port Output (Per Port) Enable Enable | Disable
Bypass Enable Enable | Disable
Port Label (Per Port) Null 0 – 20 ASCII printable characters
Alarm Elevation 86 400 s 60 – 500 000 s, 0 is disabled
Squelching (Per Port) 0 1 – 16, 0 is disabled
Table 8-15. JCC Output Module Configuration Settings (Continued)
Configuration Setting Factory Default Range

Symmetricom SSU-2000 Specifications

General

Brand	Symmetricom
Model	SSU-2000
Category	Power Supply
Language	English