Symmetricom SSU-2000 Technical Reference

12713020-003-2 Revision F.01 – January 2007 SSU-2000 Technical Reference 241
Chapter 3 ICS Command Reference
RESTART
RESTART
Use this command to restart the software for a specified module.
Level 0 Not applicable
Level 1 Not applicable
Level 2 Not applicable
Level 3
RESTART xAy
Use this command to restart the specified module. The command
requires a valid module address.
This command requires the whole entry RESTART to be entered to
verify that you want to restart the module. This command requires a
confirmation (YES | NO). If confirmation fails, no action is required.
Level 4 Same as Level 3 operation
Remarks None
Related None
RestrictionsThis command is based on the target modules that have the SPI
software RESTART command support. This command assumes that the
target module is working properly. If the target module does not work,
this command has no effect.
Note: This command does not work on the Buffer module.

Symmetricom SSU-2000 Specifications

General

Brand	Symmetricom
Model	SSU-2000
Category	Power Supply
Language	English