Symmetricom SSU-2000 Technical Reference

Chapter 2 TL1 Reference
Retrieve NTP Status
96 SSU-2000 Technical Reference 12713020-003-2 Revision F.01 – January 2007
Retrieve NTP Status
This command returns the current Network Timing Protocol (NTP) status of the
SSU-2000.
Syntax
RTRV-STATUS-NTP:[tid]::ctag;
Response Format
Up to three NTP IP addresses may be listed.
^^^ip1,offset,delay,dispersion,stratum,smode"<cr lf>
^^^ip2,offset,delay,dispersion,stratum,smode"<cr lf>
^^^ip3,offset,delay,dispersion,stratum,smode"<cr lf>
^^^SYS:mode,sysIp,sysOffset"<cr lf>
where:
 ip = the server IP address used by the client or broadcast client or broadcast
server
 offset = the number of seconds (partial seconds) that the local time was
adjusted by
 delay = the calculated delay in the communication path
 dispersion = a value that indicates the accuracy of the offset/delay settings
 stratum = stratum number of the peer
 smode = source mode [SERVER | BROADCAST]. Up to three NTP entries may
be listed
 mode = operational mode [GPS | CLIENT | LOCAL]
 sysIp = the system peer’s IP address
 sysOffset = system peer offset
Example
SSU_2000 06-05-30 14:16:58
M 100 COMPLD
"172.16.21.19,(0.002249),(0.004485),(0.125549),1,SERVER"
"172.16.21.42,(0.001745),(0.006743),(0.125640),1,SERVER"
"SYS:CLIENT,172.16.21.19,(0.001997)"
;
Related Commands
Retrieve NTP Parameters, on page 95
Set NTP Parameters, on page 163

Symmetricom SSU-2000 Specifications

General

Brand	Symmetricom
Model	SSU-2000
Category	Power Supply
Language	English