12713020-003-2 Revision F.01 – January 2007 SSU-2000 Technical Reference 255
Chapter 3 ICS Command Reference
USERS
ADD Use this option to add a user to the system. If the user
exists in the system, this option exits with an error. After the
user ID is entered, you are prompted for a password.
Password entries are echoed as ‘*’. Valid password
characters are upper case, alphanumeric characters. After
you enter the password, you are prompted for the user level
(1 through 4).
PWD Changes the password of the specified user. If the user id is
not in the system, this command exits with an error.
Password confirmation is required. This command requires
username and password as its operands.
DELETE Deletes the specified user from system. If the user id is not
in the system, this command exits with an error. This
command requires
username as its operand.
ACCESS Changes the access level of a specified user. If the user id
is not in the system, this command exits with an error. Once
the user is entered, the user shall be prompted to change
the access level. This command requires
username and
password as its operands.
TEMPPWD Provides a temporary password to a specified user. The
user at first login must change this temporary password.
This command requires
username and password as its
operands.
DISABLE Disables, enables, or unlocks the specified user in the
ENABLE system.
UNLOCK
Remarks TL1 requires user names and passwords to be limited to 10 characters.
Related LOGIN, BYE, SECURITY
RestrictionsNone