Chapter 6 Alarms and Events
Clock Module Alarms and Events
292 SSU-2000 Technical Reference 12713020-003-2 Revision F.01 – January 2007
132 Module Disabled A user has disabled a Clock module.
133 Module Restarting A user has requested a reboot.
144 Clock Select A user has selected a Clock module to be Active.
145 Set Software PLL Status of the software phase-locked loop.
146 Input Select The identified input port is selected.
147 Output PQL A user has changed the output PQL value.
148 Bypass Clock C selection A user has set the selected input as an output source.
149 Acq-Sync Operation The status of the sync operation.
150 Subtending A user has changed the operating mode.
194 User Change Warmup Time A user has changed the oscillator warmup time setting.
195 User Change Start TC A user has changed the starting Time Constant (tau).
196 User Change Default TC A user has changed the default Time Constant (tau).
199 User Change Clock Switch A user has changed the Clock Auto-Return mode.
200 User Change Input Switch A user has changed the Clock Auto-Switch mode.
201 User Change LO External
Output
A user has changed the Local Oscillator Output on the LO Output
connector.
202 User Change Input
Selection Mode
A user has changed the reference selection mode.
203 User Change Sync Speed A user has changed sync speed.
251 Alarm Error Delay Time
Changed
A user has changed the Alarm Delay time.
252 Alarm Level Changed A user has changed the Alarm level.
253 Elevation Time Changed A user has changed alarm elevation time.
254 Setup Changed A user has set the module’s configuration.
Table 6-2. Clock Module Alarm and Event Messages (Continued)
Alarm/
Event/
Trap ID
Typical Alarm/Event/Trap
Response
Description/
Corrective Action
To Next Page
Loading...
Need help?
General
