Symmetricom SSU-2000 Technical Reference

12713020-003-2 Revision F.01 – January 2007 SSU-2000 Technical Reference 295
Chapter 6 Alarms and Events
Communication Module Alarms and Events
009 Detect Mdl Removed, Fault A module has been removed from the system or is not responding
to Comms module queries. Replace the removed module with the
same type, or issue the command CONFIG xAy REMOVE to
remove the module information from the system database.
105 KeepAlive, SSU2000 The Keep Alive function has been enabled/ disabled.
129 Install, Comm Module The Comms module has been installed.
130 Remove, Comm Module The Comms module has been removed.
131 Enable, Comm Module,
COML
The Comms module has been enabled.
132 Disable, Comm Module,
COML
The Comms module has been disabled.
133 Restart, in 5 seconds,
COML
The Comms module has been rebooted (Warm boot).
144 Log In, JAY, COML, level: 2 User at indicated level has logged in.
145 Log Out,TIM, COML, level: 2 User at indicated level has logged out.
146
Auto Out, TIM, COML, level: 3 System automatically logging out a user.
147 Msg, <HELLO BILL>, COML Message sent from a user.
148 Not Acknowledged, 1A01 Module configuration could not be obtained.
150 Module Status, Fault, 1A04 Module did not boot properly.
151 UTC Time, Valid Time of startup; NTP is enabled but GPS time not being used.
152 TODSYNC, Timeout Time of day (TOD) was requested by the Comms module, no
response from the GPS module.
153 Upload Image, Start System firmware upgrade status.
154 Upgrade, 1A02 Module’s firmware upgrade has started.
155 Upgrade ACK, 1A02 Module’s firmware upgrade was completed.
156 Upgrade NAK, 1A02 Module’s firmware upgrade was not completed.
157 Config, 1A06, Not Support Call Symmetricom Global Services. Return to factory.
158 NTP Mode, GPS The SSU is configured with NTP running in an NTP Client,
Broadcast, or Broadcast Client server mode; Local is displayed
when NTP server is initialized. If GPS is not installed or setup, or
NTP has not been configured NTP remains in Local mode and uses
Comms module time.
159 Reset, Clk-B, COML A user has reset the specified clock.
160 Clk-C Source, 1A04-01 Bypass clock source has changed.
161 Sync Clk-C, Start Status of Sync acquire operation.
Table 6-4. Basic and Basic +NTP Communications Module Alarm and Event Messages (Continued)
Alarm/
Event/
Trap ID
Typical Alarm/Event/Trap
Response
Description/
Corrective Action

Symmetricom SSU-2000 Specifications

General

Brand	Symmetricom
Model	SSU-2000
Category	Power Supply
Language	English