Chapter 6 Alarms and Events
Communication Module Alarms and Events
302 SSU-2000 Technical Reference 12713020-003-2 Revision F.01 – January 2007
151 UTC Time, Valid Time of startup; NTP is enabled but GPS time not being used.
152 TODSYNC, Timeout Time of day (TOD) was requested by the Comms module, no
response from the GPS module.
153 Upload Image, Start System firmware upgrade status.
154 Upgrade, 1A02 Module’s firmware upgrade has started.
155 Upgrade ACK, 1A02 Module’s firmware upgrade was completed.
156 Upgrade NAK, 1A02 Module’s firmware upgrade was not completed.
157 Config, 1A06, Not Support Call Symmetricom Global Services. Return to factory.
158 NTP Mode, GPS The SSU is configured with NTP running in an NTP Client,
Broadcast, or Broadcast Client server mode; Local is displayed
when NTP server is initialized. If GPS is not installed or setup, or
NTP has not been configured NTP remains in Local mode and uses
Comms module time.
159 Reset, Clk-B, COML The clock listed was reset by a user.
160 Clk-C Source, 1A04-01 Bypass clock source has changed.
161 Sync Clk-C, Start Status of Sync acquire operation.
192
InitUserTable, JAY, COML
Administrator initialized user database.
193
Add User, DONNA, COML
Administrator added a user to user database.
194 Mod User, CALEB, COML User/Administrator modified user database.
195 Del User, TEST1, COML Administrator deleted user from user database.
196 Pql Table, DS1, pql(5)=ST2,
COML
PQL database has been modified.
197 Pql Factory Dflt, COML PQL database has been set to factory defaults.
198 Unit Name, , COML The SSU name has been changed.
199 NTP Peer Add, 192.5.41.
40, CLIENT, COML
An NTP client was added at the IP address shown.
200 NTP Peer Del, 192.5.41. 40,
COML
An NTP client was deleted at the IP address shown.
201 NTP Brd Timer, 64 seconds,
COML
The NTP broadcast server timer has been set to the interval shown.
202 SNMPv2 User, ADD, id=1,
COML
An SNMP user has been added to the user table in the position
shown.
203 SNMP Agent, V2, COML The SNMP mode has been enabled.
Table 6-7. Basic +SNMPv3 and Basic +NTP + SNMPv3 Communications Module Alarm and Event Messages
(Continued)
Alarm/
Event/
Trap ID
Typical Alarm/Event/Trap
Response
Description/
Corrective Action
To Next Page
Loading...
Need help?
General
