12713020-003-2 Revision F.01 – January 2007 SSU-2000 Technical Reference 53
Chapter 2 TL1 Reference
Retrieve DS1/E1 Output Parameters
bypass = allow Clock C selection: [ON | OFF]
zs = zero suppression [ON | OFF]
crc = error checking [ON | OFF]
bit = SSM bit [4 – 8] for E1 sync status messages
Line 2 contains:
aid = module access identifier
pstate# = port enabled state [1 | 0] (1 = ON and 0 = OFF), and # is the port
number [1 – 20]
Line 3 contains:
aid = module access identifier
len# = line length setting in feet [133 | 266 | 399 | 533 | 655] for all 20 DS1 output
ports,and
# is the port number [1 – 20]
Related Commands
Set DS1/E1 Output Parameters, on page 143
To Next Page
Loading...
Need help?
General
