Xerox Phaser 3610 - Page 158

Troubleshooting
Phaser 3610, WorkCentre 3615 Service Manual2-100
035-793
Fax Communication Error
035-793
Digital line detected, an analog
line is required
Job canceled. Please confirm
fax line is Analog
and not Digital. If error persists,
contact phone provider.
*Caution screen with Close
button
<Digital Line Detection>
Cause:
Connected to digital line and cannot
connect.
(Detect when connecting to line.)
FIP 1. 251
041-340
Engine NVRAM Error 041-340
Power Off/On the Printer.
If this failure occurs again,
please contact customer sup-
port.
Code:xxxxxxxxh
<IOT NVRAM Error>
Cause:
The operation error of NVM
(read/write check error etc.) is
detected.
FIP 1. 252
041-347
Engine Controller Error 041-
347
Power Off/On the Printer.
If this failure occurs again,
please contact customer sup-
port.
<IOT I/F Failure>
Cause:
MCU Internal Error (I/F part).
FIP 1. 253
042-313
Fan Motor Error 042-313
Power Off/On the Printer.
If this failure occurs again,
please contact customer sup-
port.
<LVPS Fan Motor Failure>
Cause:
MCU detects an error upon receiving
error signal from the LVPS Fan.
FIP 1. 254
042-330
IOT Start Error 042-330
Power Off/On the Printer.
Contact customer support if this
failure is repeated.
<Rear Fan Failure>
Cause:
MCU detects an error upon receiving
error signal from the Rear Fan.
FIP 1. 255
042-700
Printer Error 042-700
Power Off/On the Printer.
If this failure occurs again,
please contact customer sup-
port.
<IOT Over Heat Stop>
Cause:
The temp. Sensor sensed high temper-
ature.
FIP 1. 256
Status
Code
(3615)
LCD Display Name/Description of Error FIP