Values are the same for each input signal. The channel numbers are
shown after the parameter name in the HMI and PCM600.
8.3.3 Settings
Setting tables for all A1RADR and A2RADR channels are similar except for the
channel numbers.
Table 1444: A1RADR Non group general settings (basic)
Parameter Values (Range) Unit Step Default Description
Operation
1=on
5=off
1=on
Analog channel
on / off
Channel id text Analog ch 1 input Channel identifier
text
High trigger level 0.00...60.00 0.01 10 Over limit
Low trigger level 0.00...2.00 0.01 0 Under limit
Table 1445: A1RADR Non group general settings (advanced)
Parameter Values (Range) Unit Step Default Description
Storage mode
0=Waveform
1=Trend / cycle
0 Storage mode se-
lection (waveform /
trend)
8.4 Disturbance recorder, binary channels 1...64
B1RBDR and B2RBDR
Measurement functions 1MRS759142 F
1496 REX640
Technical Manual
To Next Page
Loading...
