R5905948 /12 Event Master Devices174
Custom Format Adjust tab – top half
This menu provides:
• H Total: The total pixel count per line.
• H Front Porch: The offset between the end of the
active area and the beginning of H sync.
• H Active: The horizontal size in pixels of the active
area.
The IP address may be entered manually.
• H Sync: The H sync width in pixels.
• H Polarity: The polarity (active High or Low) of the
horizontal sync pulse (N/A in SDI).
• V Total: The total line count per frame.
• V Front Porch: The offset in lines between the
end of the output active area and the beginning of
V sync.
• V Active: The vertical size of the output active
area.
• V Sync: The V sync width in lines.
• V Polarity: The polarity (active High or Low) of the
vertical sync pulse (N/A in SDI).
• V Rate: Adjusts the frame rate in seconds polarity
(active High or Low) of the vertical sync pulse (N/A
in SDI).
• Connector Capacity needed: Lists the connector
capacity (SL, DL, 4K, etc.) that is required.
The connector graphic shows whether the
connectors can support the custom format (green
LED) or not (red LED).
• The Apply Changes button applies the changes to
the custom format.
EM GUI orientation
To Next Page
Loading...