The NET List
Manpack Transceiver 2110 series Reference Manual 161
LQA Exchange
The LQA Exchange setting determines whether or not the exchange of LQA information
occurs during calls within the NET. If this is set to Enabled, the transceiver adds an
appropriate amount of time to the slot widths so that LQA information can be exchanged.
Slot Width
The Slot Width setting determines the width of response slots for each member of the
NET. If the Slot Width setting is set to Fixed, then all slot widths match the width
required for the largest member address for the NET. However, this extends the time to
complete the handshake considerably. Unless required for interoperability reasons, the
recommended setting is Variable. In this case, the transceiver calculates the exact slot
width required for the response from each station.
CAUTION This setting must be the same in all member stations.
CAUTION This setting must be the same in all member stations.
To Next Page
Loading...
Need help?
General
