The Control List
262 Manpack Transceiver 2110 series Reference Manual
Showing distance and bearing
To show the distance and bearing to a remote transceiver from your current valid GPS
position:
1 Go to an Address List or Call Log entry containing a GPS position of the remote
transceiver.
The transceiver automatically calculates the distance to the remote transceiver and
its bearing from true north with respect to your current location.
NOTE
Automatic distance and bearing calculations only occur when Option GPS
Enable is installed.
CAUTION
You must have valid GPS information stored in your transceiver from
either of the following sources:
• a connected GPS receiver, or
• the My GPS entry in the Address List (if you don’t have a GPS
receiver connected)
CAUTION
If you don’t have a GPS receiver connected and are using the
My GPS entry in the Address List to enable the distance and bearing
display, you should set the GPS Error Time entry in the Control List
to Off.
To Next Page
Loading...
Need help?
General
