Operating the transceiver from a computer
448 Manpack Transceiver 2110 series Reference Manual
ptt [off|on] [data|voice|talk] Displays the current PTT state of the transceiver and
places the transceiver into PTT for 30 seconds.
Sets the PTT to:
• receive mode (off) with a data, voice or talk signal
• transmit mode (on) with a data, voice or talk signal
scan [<network>|off|on] Displays the current scanning state of the transceiver, and
if scanning is on, displays the names of networks that are
currently being scanned.
Switches scanning off or on.
Switches to the network specified and begins scanning on
that network.
secure [corp [#<nn>]|global|off|on
[PIN]]
Displays the current state of the encryptor.
Switches on CES Corporate/Global secure mode, or the
default mode of the CES-128 voice encryptor (with or
without a specified PIN).
Switches on AES-256 secure mode (global and PIN are
not applicable).
Switches off the encryptor.
secure index [n] Displays the current secure index or selects 1 of n
different CES secure keys or AES secure keys. Requires
login by administrator.
secure key [#n] [<key>] For CES-128 voice encryptors, sets the Base secure key
(in secure index #0) or CES secure keys (in indexes #1 to
#98).
For AES-256 digital voice encryptors, sets the AES
secure keys for indexes 1 to 255.
Requires login by administator.
secure key erase Erases all CES secure keys and AES secure keys in the
transceiver. Requires login by administrator.
NOTE
The Base secure key is not erased from the
CES-128 voice encryptor.
secure mode [corp|global] Sets the default mode of the CES-128 voice encryptor
(Corporate or Global). Requires login by administrator.
secure numkeys Displays the total number of CES secure keys or AES
secure keys programmed into the transceiver.
selbeacon <address of called
station>[@<network>] [±scan] [s]
[from <self
address>[@<network>]]
Makes a Channel Test call to an addressed station using
any, or the specified, ALE/CALM or Codan Selcall
network from the self address specified.
Table 68: Summary of CICS command syntax (cont.)
Command syntax Function
To Next Page
Loading...
Need help?
General
