A
B
C
D
E
F
G
H
L
M
N
P
section
N 9.1
1871098/1098S - M.Y. 2007 - edition 00
Engine
Use a feeler gauge to check the clearance between the engine sensor (23) and the timing gear (13). The values must be between
0.6 and 0.8 mm.
Notes
If the gap is incorrect, loosen the screw (25) of the engine sensor and replace the shim (24) with one of suitable thickness
(paragraph “Checking the engine sensor air gap”).
Install the oil vapour breather valve (1) in the crankcase along with O-ring (2).
Tighten the bolt (17) to the specified torque (Sect. C 3, Engine torque settings).
Tighten the two oil hose connection nipples (8) with the seals (27) to the specified torque (Sect. C 3).
23
13
25
24
1
17
2
LOCK
8
To Next Page
Loading...
