A
B
C
D
E
F
G
H
L
M
N
P
section
P 7
931098/1098S - M.Y. 2007 - edition 00
Electric system
When you switch the LAP function off using the menu, the lap in progress is not saved.
If the LAP function is active and the display is suddenly switched off (Key-Off), the LAP function is switched off automatically
(even if the timer was ON, the lap in progress is not saved).
If the timer is not stopped, when it reaches 99 minutes, 59 seconds and 99 hundredths of a second, it restarts from 0 (zero) and
continues until the function is switched off.
If, however, the LAP function is switched on and the memory has not been cleared, but the less than 30 laps have been saved
(e.g. 18 laps), the display will save any remaining laps until the memory is full (in this case, it will save a further 12 laps).
In this function, lap time only is displayed, but other data are also saved (MAX speed, MAX rpm, limiter if reached) for viewing at
a later date in the Lap Memory function.
press C
after 10 sec.
press C
after 10 sec.
To Next Page