A
B
C
D
E
F
G
H
L
M
N
P
section
P 7
94 1098/1098S - M.Y. 2007 - edition 00
Electric system
LAP Memory display
Displays the data saved with the LAP function: lap time, MAX speed and MAX rpm.
To display the saved times, go into the menu and select the “LAP MEM” page.
From this page, if you hold button (1) in position B “▼” for 3 seconds, the data for the first lap will appear. The display will show
the lap number, lap time, MAX speed and the MAX rpm reached for the lap in question.
If you switch the button (1) to position B “▼”, the display scrolls through the 30 saved times, before returning to the 1
st
lap.
If you hold the button (1) in position B “▼” for 3 seconds while displaying the saved times, the display immediately resets all the
saved times. In this case, if the LAP function was active, it is switched off automatically.
The MAX speed saved is the maximum speed indicated on the display in Lap function.
If when saving the MAX speed the indication exceeds 299 km/h (186 mph), the speed reached is displayed (e.g. 316 km/h
If there is no reading in the memory, the 30 times are shown, with the timer displaying “00.00.00”, MAX rpm = 0 and MAX
speed = 0.
1
B
press B
press B..x 19
B= On 3 sec.
Resetting all times in memory
press B..x 19
press A
press B
press A
press A
press A
press B
To Next Page
Loading...
