A
B
C
D
E
F
G
H
L
M
N
P
section
P 8
1051098/1098S - M.Y. 2007 - edition 00
Electric system
Programming aborted:
if you allow the 3 second countdown after Key-On or the 15 second countdown after Key-Off to elapse, or you make a mistake
in the programming procedure, the instrument panel will abort the programming operation and display the message “OFF” for
3 seconds before returning to the normal display mode.
Important
During the programming procedure, the instrument panel, in addition to saving the key codes in memory, retrieves two
“electronic” codes from insertion of KEY 1 (first key to be inserted) and KEY 2 (second key to be inserted).
If the Immobilizer is reprogrammed, the key codes will be erased and replaced with the new codes of the new keys; the two
“electronic” codes, however, remain permanently in memory and cannot be deleted or overwritten.
The code on the Code Card corresponds to one of the two electronic codes and is used for Immobilizer Recovery and Immobilizer
Reprogramming.
To Next Page
Loading...
