FOR-A FA-9520 - Page 196

196
assignments will be changed to that of the Input Selection. Direct Input Selection and Dolby
Decoder Output signals cannot be input to the Dolby encoder together. Dolby Digital signal
output from the Dolby decoder, Dolby Decoder Output, cannot be encoded to the Dolby E
signal.
*2 Not shown if the FA-95ALA option is not installed in option slot A.
*3 Not shown if the FA-95ALA option is not installed in option slot B.
Dolby Encoder Mode Setting
Parameter
Default
Setting range
Description
Program
Configuration
5.1+2
5.1+2
*1
5.1+2x1
*1
4+4
*1
4+2x2
*1
4+2+2x1
*1
4+4x1
*1
4x2
*1
3x2+2x1
*1
2x2+4x1
*1
2+6x1
*1
8x1
*1
5.1
4+2
4+2x1
3x2
2x2+2x1
2+4x1
6x1
4
2+2
2+2x1
4x1
7.1
*1
7.1 Screen
*1
Selects Dolby E encoder program
configuration.
Bit Depth
20bit
20bit
16bit
Selects the bit width of the Dolby E
encoder output.
Frame REF
FS1
FS1
FS2
Selects a video output to which the
Dolby E encoder output is
synchronized. (FS 1 or FS 2)
Meta Data
Input
Internal
Internal
Dolby Decoder Output
Selects a metadata to be used for
Dolby E encoding.
Internal: Uses the Program
Configuration and Bit Depth settings.
Other metadata will be reset to
default.
Dolby Decoder Output: Uses the
metadata of the Dolby E signal input
to the Dolby decoder.
Program Configuration and Bit
Depth will be ineffective.
*1 If Bit Depth is set to 16bit, the “＊“ will be displayed and the program functions as 5.1. To
select these configurations, set Bit Depth to 20bit.