211
FS1/FS2 ANC Loss Mode Settings
Allows you to select an operation mode when input signal ancillary data is lost.
S2016-3 AFD
RP186 VI
BT1119 WSS
Selects an ancillary data type to insert
into the SDI signal.
Selects a video format compatible with
the ancillary data selected under ANC.
Only compatible Video formats will be
displayed
If Format is set to SD
Remove *2
Hold *2
4:3 L 16:9 T *2
4:3 L14:9 T *2
4:3 L>16:9 *2
4:3 F 4:3 *2
4:3 L16:9PRTD *2
4:3 L 14:9 *2
4:3 F ALT14:9 *2
4:3 L ALT14:9
4:3 L ALT 4:3
16:9 L>16:9
16:9 F 16:9 *2
16:9 P 4:3
16:9 F PRTD
16:9 P 14:9
16:9 P ALT14:9
16:9 F ALT14:9
16:9 F ALT4:3
Mode can be set for respective ANC
and Format selections.
Remove: Does not embed the ancillary
data to either FS1, or 2
Hold: Retains the last ancillary data
aspect ratio and outputs video signal in
the aspect ratio.
Other values operate according to the
selected AFD as an input AFD.
BT1119 WSS selected under ANC can
only select AFD codes indicated by
*2
.
If Format is set to HD
Remove
Hold
16:9 L>16:9
16:9 F 16:9
16:9 P 4:3
16:9 F PRTD
16:9 P 14:9
16:9 P ALT14:9
16:9 F ALT14:9
16:9 F ALT4:3
Mode can be set for respective ANC
and Format selections.
Remove: Does not embed the ancillary
data to either FS1, or 2
Hold: Retains the last ancillary data
aspect ratio and outputs video signal in
the aspect ratio.
Other values operate according to the
selected AFD as an input AFD.
*1 HD is selectable only when ANC is set to S2016-3.
FS1/FS2 WSS AFD Error
Allows you to select the WSS AFD ancillary operation mode when the input signal WSS AFD
ancillary data is lost.
Remove: Does not embed BT1119 WSS to
FS1 and/or 2.
F 4:3: Embeds BT1119 WSS F 4:3 (code 8)
to FS1 and/or 2.
Ancillary data insersion line settings specified under ANC Settings (sec. 9-4-3) take
priority over the line settings specified under the FS1, FS2 SD LINE MASK (sec. 9-4-1)
and will take effect.
To Next Page
