214
*2 The input functions consist of pulse mode and level mode functions. See the “◆INPUT
FUNCTION” in section 7-6 “GPI SETTING” for details.
*3 Details of the output functions are shown in the “◆OUTPUT FUNCTION” in section 7-6 “GPI
SETTING”.
*4 If FS Mode > Synchro Mode in section 9-4-1 “FS1/FS2 Video System” is set to Line Sync, or
AVDL, the Freeze setting will not function, but will be displayed as *Freeze.
To enable Freeze for Input, be sure to set Synchro Mode in section 9-4-1 “FS1/FS2 Video
System” to Frame Sync.
*5 DC Power 1 and 2 are selectable only if FA-95PS is installed.
*6 Shown only if the FA-95AIO option is installed in slot A.
*7 Shown only if the FA-95AIO option is installed in slot B.
*8 The Logo ID setting box will be displayed when In/Out is set to Input, and Assign is set to any
of FS1 Load 1 – 7 or FS2 Load 1 – 7. In the following cases, the logo will not be inserted to the
converter output signals, although data will be loaded to the FA-9520.
- No logo is registered under the selected Logo ID.
- The registered logo format and converter output video format do not match.
- The keyer of the relevant converter is turned off.
To Next Page
Loading...
