7½ Digit Graphical Sampling Multimeter Reference Manual Section 2:
DMM7510-901-01 Rev. B / May 2015 2-109
Figure 73: Rear panel connections: 2-wire resistance measurement
Measure 2-wire resistance using the front panel
To make a 2-wire resistance measurement using the front panel:
1. Make the connections as shown in the previous figures.
2. Press the FUNCTION key.
3. Select 2W Res.
4. If the measurement method is set to continuous, the measurements start displaying on the
front-panel display.
If the measurement method is set to manual or trigger model, press the TRIGGER key to make a
measurement.
Settings available for 2-wire resistance measurements
See 2-wire resistance measure settings (on page 2-27) for settings that are available when you are
making 2-wire resistance measurements.
To Next Page
Loading...
