Keithley DMM7510

Section
3: Functions and features Model DMM7510 7½ Digit Graphical Sampling Multimeter
Reference Manual
3-114 DMM7510-901-01 Rev. B / May 2015
TSP-Link commands
Command Description
trigger.tsplinkin[N].clear() (on page 8-338)
Clears the event detector for a trigger
trigger.tsplinkin[N].edge (on page 8-339)
Indicates which trigger edge controls the trigger
event detector for a trigger line
trigger.tsplinkin[N].overrun (on page 8-340)
Indicates if the event detector ignored an event
while in the detected state
trigger.tsplinkin[N].wait() (on page 8-340) Waits for a trigger
trigger.tsplinkout[N].assert() (on page 8-341)
Simulates the occurrence of the trigger and
generates the corresponding trigger event
trigger.tsplinkout[N].logic (on page 8-342) Defines the trigger output with output logic for a
trigger line
trigger.tsplinkout[N].pulsewidth (on page 8-
342)
Sets the length of time that the trigger line is
asserted for output triggers
trigger.tsplinkout[N].release() (on page 8-343)
Releases a latched trigger on the given TSP-Link
trigger line
trigger.tsplinkout[N].stimulus (on page 8-344)
Specifies the event that causes the
synchronization line to assert a trigger
tsplink.group (on page 8-346)
The group number of the TSP-Link node
tsplink.initialize() (on page 8-347)
Initializes all instruments and enclosures in the
TSP-Link system
tsplink.line[N].mode (on page 8-348)
Defines the trigger operation of a TSP-Link line
as digital in or out or trigger in or out
tsplink.line[N].reset() (on page 8-349)
Resets some of the TSP-Link trigger attributes to
their defaults
tsplink.line[N].state (on page 8-350) Reads or writes the digital state of a TSP-Link
synchronization line
tsplink.master (on page 8-350)
Reads the node number assigned to the master
node
tsplink.node (on page 8-351) Defines the node number
tsplink.readport() (on page 8-351)
Reads the TSP-Link synchronization lines as a
digital I/O port
tsplink.state (on page 8-352)
Describes the TSP-Link online state
tsplink.writeport() (on page 8-352)
Writes to all TSP-Link synchronization lines as a
digital I/O port