Keysight Technologies InfiniiVision DSOX1204G

Root (:) Commands 6
Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 149
Query Syntax :OPEE?
The :OPEE? query returns the current value contained in the Operation Status
Enable register as an integer number.
Return Format
<value><NL>
<value> ::= integer in NR1 format.
See Also • "Introduction to Root (:) Commands" on page 135
• ":AER (Arm Event Register)" on page 136
• ":CHANnel<n>:PROTection" on page 217
• ":OPERegister[:EVENt] (Operation Status Event Register)" on page 152
• ":OVLenable (Overload Event Enable Register)" on page 154
• ":OVLRegister (Overload Event Register)" on page 156
• "*STB (Read Status Byte)" on page 127
• "*SRE (Service Request Enable)" on page 125
3 Run Running Event when the oscilloscope is running (not
stopped).
2-0 --- --- (Not used.)
Table 47 Operation Status Enable Register (OPEE) (continued)
Bit Name Description When Set (1 = High = True), Enables: