4 Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide
• Chapter 8, “:ACQuire Commands,” starting on page 177, describes commands
for setting the parameters used when acquiring and storing data.
• Chapter 9, “:CALibrate Commands,” starting on page 191, describes utility
commands for determining the state of the calibration factor protection button.
• Chapter 10, “:CHANnel<n> Commands,” starting on page 201, describes
commands that control all oscilloscope functions associated with individual
analog channels or groups of channels.
• Chapter 11, “:DEMO Commands,” starting on page 223, describes commands
that control the education kit (EDK license) demonstration signals that can be
output on the oscilloscope's Demo terminal.
• Chapter 12, “:DISPlay Commands,” starting on page 227, describes commands
that control how waveforms, graticule, and text are displayed and written on
the screen.
• Chapter 13, “:DVM Commands,” starting on page 241, describes commands
that control the optional DSOXDVM digital voltmeter analysis feature.
• Chapter 14, “:EXTernal Trigger Commands,” starting on page 249, describes
commands that control the input characteristics of the external trigger input.
• Chapter 15, “:FFT Commands,” starting on page 259, describes commands that
control the FFT (Fast Fourier Transform) function for displaying the frequence
content of a waveform.
• Chapter 16, “:FRANalysis Commands,” starting on page 273, describes
commands that control oscilloscope functions associated with the Frequency
Response Analysis (FRA) feature, which is available in G-suffix oscilloscope
models (that have a built-in waveform generator).
• Chapter 17, “:FUNCtion Commands,” starting on page 289, describes
commands that control math waveforms.
• Chapter 18, “:HARDcopy Commands,” starting on page 311, describes
commands that set and query the selection of hardcopy device and formatting
options.
• Chapter 19, “:MARKer Commands,” starting on page 325, describes commands
that set and query the settings of X-axis markers (X1 and X2 cursors) and the
Y-axis markers (Y1 and Y2 cursors).
• Chapter 20, “:MEASure Commands,” starting on page 341, describes
commands that select automatic measurements (and control markers).
• Chapter 21, “:MTESt Commands,” starting on page 399, describes commands
that control the mask test features provided with Option LMT.
• Chapter 22, “:RECall Commands,” starting on page 433, describes commands
that recall previously saved oscilloscope setups, reference waveforms, or
masks.
• Chapter 23, “:SAVE Commands,” starting on page 441, describes commands
that save oscilloscope setups, screen images, and data.
To Next Page
Loading...
Need help?
General
