Keysight InfiniiVision DSOX1204A/G Oscilloscopes Programmer's Guide 5
• Chapter 24, “:SBUS<n> Commands,” starting on page 461, describes
commands that control oscilloscope functions associated with the serial
decode bus and serial triggering.
• Chapter 25, “:SYSTem Commands,” starting on page 545, describes
commands that control basic system functions of the oscilloscope.
• Chapter 26, “:TIMebase Commands,” starting on page 573, describes
commands that control all horizontal sweep functions.
• Chapter 27, “:TRIGger Commands,” starting on page 585, describes commands
that control the trigger modes and parameters for each trigger type.
• Chapter 28, “:WAVeform Commands,” starting on page 633, describes
commands that provide access to waveform data.
• Chapter 29, “:WGEN Commands,” starting on page 669, describes commands
that control waveform generator (Option WGN) functions and parameters.
• Chapter 30, “:WMEMory<r> Commands,” starting on page 701, describes
commands that control reference waveforms.
• Chapter 31, “Obsolete and Discontinued Commands,” starting on page 711,
describes obsolete commands which still work but have been replaced by
newer commands and discontinued commands which are no longer supported.
• Chapter 32, “Error Messages,” starting on page 757, lists the instrument error
messages that can occur while programming the oscilloscope.
The command descriptions in this reference show upper and lowercase characters.
For example, :AUToscale indicates that the entire command name is :AUTOSCALE.
The short form, :AUT, is also accepted by the oscilloscope.
Then, there are chapters that describe programming topics and conceptual
information in more detail:
• Chapter 33, “Status Reporting,” starting on page 765, describes the
oscilloscope's status registers and how to check the status of the instrument.
• Chapter 34, “Synchronizing Acquisitions,” starting on page 787, describes how
to wait for acquisitions to complete before querying measurement results or
performing other operations with the captured data.
• Chapter 35, “More About Oscilloscope Commands,” starting on page 797,
contains additional information about oscilloscope programming commands.
Finally, there is a chapter that contains programming examples:
• Chapter 36, “Programming Examples,” starting on page 807.
See Also • For more information on using the SICL, VISA, and VISA COM libraries in
general, see the documentation that comes with the Keysight IO Libraries
Suite.
• For information on controller PC interface configuration, see the
documentation for the interface card used (for example, the Keysight 82350A
GPIB interface).
• For information on oscilloscope front-panel operation, see the User's Guide.
To Next Page
Loading...
Need help?
General
